Suzuki Liana RH418 Supplementary Service Manual page 356

5A-130 Automatic Transmission/Transaxle:
73) Wipe off and clean mating surface between case
and side cover.
74) Apply sealant to transaxle case by using a nozzle (1)
as shown in figure by such amount that its section is
1.5 mm (0.059 in) in diameter.
"A": Sealant 99000–31230
75) Apply sealant to thread parts of 2 bolts (2, 6).
"A": Sealant 99000–31230
76) Install transaxle side cover (7) with bolts referring to
length in the following table.
Bolt: Length "L"
(1): 38 mm (1.50 in.)
(2): 60 mm (2.36 in.)
(3): 72 mm (2.83 in.)
(4): 25 mm (2.36 in.)
(5): 55 mm (2.17 in.)
(6): 25 mm (0.98 in.)
Tightening torque
Transaxle side cover bolt (a): 24 N·m (2.4 kgf-m,
17.5 lb-ft)
1, (a)
7
6, (a), "A"
5, (a)
4, (a)
3, (a)
1, (a)
I2RH01510263-01
2, (a), "A"
(a)
L
3, (a)
I2RH01510264-01
77) Install the following parts (with new O-rings installed)
with bolts.
• Valve body connector (1)
• Output shaft speed sensor (2)
• Input shaft speed sensor (3)
• Fluid filler tube (4)
Tightening torque
Input shaft speed sensor bolt (a): 5.5 N·m (0.55
kgf-m, 4.0 lb-ft)
Valve body connector bolt (b): 7.0 N·m (0.7 kgf-
m, 5.0 lb-ft)
Output shaft speed sensor bolt (c): 5.5 N·m (0.55
kgf-m, 4.0 lb-ft)
Fluid filler tube bolt (d): 5.5 N·m (0.55 kgf-m, 4.0
lb-ft)
78) Apply A/T fluid to new O-ring.
79) Install vehicle speed sensor (with new O-ring
installed) (1) with bolt.
Tightening torque
Vehicle speed sensor bolt (a): 7.0 N·m (0.7 kgf-
m, 5.0 lb-ft)
1
(a)
I2RH01510265-01
I2RH01510266-01