Sun Gear Thrust Roller Bearing Dimension; Istance Between Forward Clutch Drum And Mating Surface Of Transaxle Case - Suzuki Liana RH418 Supplementary Service Manual

5A-126 Automatic Transmission/Transaxle:
33) Temporarily tighten transaxle housing to transaxle
case with 5 – 6 bolts.
34) Stand transaxle up (i.e.: transaxle housing facing
down-ward).
35) Install front and rear planetary carrier (1) while
rotating counter-clockwise and clockwise.
36) Install sun gear (2) with sun gear thrust roller bearing
(3).

Sun gear thrust roller bearing dimension

Outside diameter: 32.5 mm (1.28 in.)
Inside diameter: 18.8 mm (0.74 in.)
Thickness: 2.7 mm (0.11 in.)
37) Apply A/T fluid to carrier rear thrust roller bearing
race (4).
38) Install carrier rear thrust roller bearing race (4) to
planetary carrier.
39) Install overdrive / coast clutch assembly (1) while
rotating counterclockwise and clockwise.
NOTE
Make sure that overdrive / coast clutch
assembly locks when turned
counterclockwise [A] and moves freely when
turned clockwise [B].
40) Install forward clutch assembly while rotating.
41) Check for correct installation of each component
parts as follows.
Measure the distance "a" by using vernier (1) and
I2RH01510245-01
straightedge (2). If out of specification, remove
forward clutch, overdrive / coast clutch, front and
rear planetary carrier and reinstall them properly.
Distance between forward clutch drum (3) and
mating surface of transaxle case
"a": 46.94 – 47.81 mm (1.848 – 1.882 in.)
42) Apply sealant to mating surface of transaxle case by
using a nozzle (2) as shown in figure by such
amount that its section is 1.5 mm (0.059 in) in
diameter.
"A": Sealant 99000–31230
I2RH01510246-01
I2RH01510247-01
I2RH01510248-01