Suzuki Liana RH418 Supplementary Service Manual page 314

5A-88 Automatic Transmission/Transaxle:
42) Remove retainer ring (1) and 1st and reverse brake
piston return spring (2).
43) Remove 1st and reverse brake piston with O-ring
installed while applying and releasing compressed
air (400 – 800 kPa, 4 – 8 kg/cm
through oil hole section (3).
NOTE
• Never reuse removed O-rings.
• If piston will not pop out, it is
recommended to use needle nose pliers
for removal.
44) Remove parking lock pawl (1), pawl bracket (2) and
torsion spring by removing two bolts.
45) Pry off torsion spring (3) of parking lock pawl (1).
46) Remove parking lock pawl (1) by pulling out pawl
shaft (4) with torsion spring installed.
47) Pullout counter driven gear assembly (5) towards
you.
2 , 57 – 113 psi)
I3RH0B510032-01
I2RH01510123-01
48) Remove countershaft thrust roller bearing (1) with
race.
Countershaft thrust roller bearing dimension
Outside diameter: 66.0 mm (2.60 in.)
Inside diameter: 51.0 mm (2.01 in.)
Thickness: 2.7 mm (0.11 in.)
49) Remove transaxle lubrication tube (2).
50) Measure torque (bearing preload) of counter drive
gear subassembly using torque wrench and special
tool.
Special tool
(A): 09927-26010
Counter drive gear bearing preload
Starting torque: 0.05 – 0.25 N⋅m (0.005 – 0.025
kgf-m, 0.037 – 0.180 lb-ft)
Rotational torque: 0.05 – 0.15 N⋅m (0.005 – 0.015
kgf-m, 0.037 – 0.108 lb-ft)
I2RH01510124-01
I2RH01510125-01