Suzuki Liana RH418 Supplementary Service Manual page 325

5) Using special tool and hydraulic press (2), compress
overdrive clutch return spring and install snap ring
(1).
Special tool
(A): 09926-98310
NOTE
• When installing return spring, be careful
so that return spring will not fall or tilt.
• Do not align opening in snap ring with lug
of overdrive clutch return spring at its
retainer section.
CAUTION
!
Be careful when applying pressure, for
overpressure will cause plate section of
spring to deform.
6) Select and measure correct thickness of coast clutch
retaining plate.
Available coast clutch retaining plate thickness
3.6 mm (0.142 in.), 3.8 mm (0.150 in.), 4.0 mm
(0.157 in.)
7) Install separate plate "S", friction plates "F" and
retaining plates "R" of coast clutch in the following
order.
R → F → S → F → R
NOTE
Be sure to confirm that flat section of
retaining plate faces toward piston side and
also that of separate plate faces toward
upper side.
8) Install snap ring (1).
NOTE
Make sure that opening end of ring is not
aligned with groove section of drum.
9) Select and measure correct thickness of overdrive
clutch retaining plate.
Available overdrive clutch retaining plate
thickness
3.6 mm (0.142 in.), 3.8 mm (0.150 in.), 4.0 mm
(0.157 in.)
10) Install separate plates "S", friction plates "F" and
retaining plates "R" of overdrive clutch in the
following order.
R → F → S → F → S → F → R
NOTE
Be sure to confirm that flat section of
retaining plate selected in Step 9) faces
I2RH01510159-01
toward piston side and also that of retaining
plate faces toward upper side.
11) Install snap ring (1).
NOTE
Make sure that opening end of ring is not
aligned with groove section of drum.
Automatic Transmission/Transaxle: 5A-99
I2RH01510154-01
I2RH01510153-01