Suzuki Liana RH418 Supplementary Service Manual page 355

65) Apply sealant to thread parts of 2 bolts (1).
"A": Sealant 99000–31230
66) Install transaxle housing to transaxle case by
tightening bolts to specified torque.
Tightening torque
Transaxle case bolt (a): 30 N·m (3.0 kgf-m, 22.0
lb-ft)
(a)
(a)
67) Insert wiring harness (1) of valve body connectors.
68) Apply A/T fluid to 2 new gaskets (2) and place them
as shown in figure.
69) While holding valve body assembly (1), connect
manual valve rod (2) to manual valve lever (3).
3
2
(a)
(a)
1, "A", (a)
(a)
I2RH01510258-01
I2RH01510259-01
1
I2RH01510260-01
Automatic Transmission/Transaxle:
70) Tighten valve body assembly (1) with bolts referring
to length in the following table.
Bolt: Length "L"
(1): 20 mm
(2): 50 mm
(3): 55 mm
(4): 75 mm
Tightening torque
Valve body bolt (a): 10 N·m (1.0 kgf-m, 7.5 lb-ft)
71) Clamp wiring harness (1) of solenoids and
transmission fluid temperature sensor.
72) Connect couplers of solenoids by identifying wire
color shown in the following table and install
transmission fluid temperature sensor (6) to its
clamp (7).
Solenoid Coupler
Pressure control solenoid valve (2)
Shift solenoid valve-A (No.1) (3)
Shift solenoid valve-B (No.2) (4)
TCC solenoid valve (5)
NOTE
There is an interchangeability between shift
solenoid valve-A and shift solenoid valve-B
for installation.
6
7
5A-129
I3RH0B510015-01
Wire Color
Pink + Brown
White
Black
Yellow
1
2
3
4
5
I2RH01510262-01