Suzuki Liana RH418 Supplementary Service Manual page 324

5A-98 Automatic Transmission/Transaxle:
5) Using special tool and hydraulic press (2), compress
overdrive clutch return spring and remove snap ring
(1).
Special tool
(A): 09926-98310
CAUTION
!
Be careful when applying pressure, for
overpressure will cause plate section of
overdrive clutch return spring to deform.
6) Remove overdrive clutch return spring.
7) For removing coast clutch piston (1), install forward
clutch assembly.
8) Remove coast clutch piston with O-rings using
compressed air (400 – 800 kPa, 4 – 8 kg/cm
113 psi) through oil hole (2).
9) Remove O-rings from coast clutch piston.
NOTE
Never reuse O-rings after removal.
10) Remove coast clutch piston (1) with O-rings using
compressed air (400 – 800 kPa, 4 – 8 kg/cm
113 psi) through oil hole (2).
11) Remove O-rings from overdrive clutch piston.
NOTE
Never reuse O-rings after removal.
Reassembly
1) Apply A/T fluid to new O-rings.
2) Install new O-rings to pistons.
I2RH01510155-01
3) Set coast clutch piston (1) to overdrive clutch piston
(2) by pushing with fingers.
4) Press overdrive clutch and coast clutch piston to
2 , 57 –
overdrive clutch drum (3).
NOTE
Make sure that O-rings are not twisted or
deviated from position during insertion of
piston.
I2RH01510156-01
, 57 –
2
I2RH01510157-01
I2RH01510158-01