System Configuration; Connection Of Power Cables And Ground Cables - Mitsubishi Electric GOT SIMPLE Series User Manual

System configuration

GOT
Use the following GOTs having a CE mark on the rating plate.
The following models are compliant with the EMC Directive at factory shipment.
When any GOT other than the following does not comply with the EMC Directive.
Product name
GS2110
GS2107
Connection type
The following table lists the connection types compliant with the EMC Directive.
○: Compliant with EMC Directive, ×: Not compliant with EMC Directive
*1
Connection type
Ethernet connection
Direct CPU connection
Computer link connection
Other connections
(Connection with non-Mitsubishi PLC, inverter, servo amplifier)
*1 For the details of each connection type, refer to the following manual.
GOT2000 Series Connection Manual (GT Works3 Version1) for the controller used
*2 When connecting the GOT to other controllers such as a non-Mitsubishi PLC, fabricate connection cables and configure the system
following the EMC Directive specifications.
Page 44 Non-Mitsubishi PLC, inverter, and servo amplifier connections
Connected devices
When connecting the GOT to a non-Mitsubishi PLC, refer to the manual about the EMC Directive compliance
of the connected device (such as a PLC and a microcomputer).

Connection of power cables and ground cables

Carry out wiring and connect the power and ground cables according to the following instruction.
By the different wiring or connection method, the system may not comply with EMC Directive.
Wiring method
For connection of power cables and ground cables, refer to the following.
Ground the frame ground terminal (FG terminal) of the GOT with the thickest and shortest cable as possible.
Page 58 Wiring Inside and Outside the Panel
5 EMC DIRECTIVE
42
5.2 EMC Directive Requirements
Model
GS2110-WTBD-N
GS2110-WTBD
GS2107-WTBD-N
GS2107-WTBD
GS21
○
○
○
*2
○