Station Apparatus
Telephone Programming Mode A
The 3000/3500-series telephones enable you to set a number of features directly from the phone,
including: Call Waiting Tone (On/Off), Flex Key, Msg Key, LCD contrast, Speakerphone/Microphone
Room Noise Sensitivity (On/Off), and Country settings. "Telephone Programming Mode A" programs
settings on a ROM chip inside the telephone.
Some of the procedures use Feature Buttons (FB1, FB2, etc.). When your telephone is in
Note
Programming Mode, the flexible buttons are numbered as Feature Buttons, as shown in
Figures 7-12
To place your telephone in Programming Mode A
3
6
9
Press
+
+
+
"SELECT=". Your phone will not ring if it receives a call while in Programming Mode.
To exit from Programming Mode A
Go Off- and On-hook or wait for 30 seconds for Programming Mode to automatically time out.
Telephone Program Option Reset
This function resets all Programming Mode A option settings to their default setting.
3
6
9
1. Press
+
+
+
Vol
2. Press
+
Hold
3. Press
to activate reset.
4. Go off-hook, then on-hook to exit the program mode.
Dial Pad and Button Beeps
Digital telephones can emit a "beep" sound whenever a dial pad or feature button is pressed. The
"beeps" are On by default. Follow these steps to turn the "beeps" On or Off on 3000/3500-series
DKTs.
3
6
9
1. Press
+
+
+
0
2. Press
.
3. Press Feature Button 1 (FB1) to toggle On/Off.
FB1, LED On: buttons beep.
FB1, LED Off: buttons do not beep.
Hold
4. Press
to set the option.
5. You must also go off-hook, then on-hook to exit the program mode.
7-16
and 7-14.
Hold
simultaneously. The LCD displays "DKT PROGRAM MODE" and
Hold
(simultaneously).
Msg
Msg
(
LED On means reset is set to activate)
Hold
(simultaneously).
Strata CTX I&M September 2002