Mvr Type - Edge-Core ES3528MV2 Management Manual

C M
OMMAND
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND
Immediate leave applies only to receiver ports. When enabled, the
◆
receiver port is immediately removed from the multicast group
identified in the leave message. When immediate leave is disabled, the
switch follows the standard rules by sending a group-specific query to
the receiver port and waiting for a response to determine if there are
any remaining subscribers for that multicast group before removing the
port from the group list.
Using immediate leave can speed up leave latency, but should only be
◆
enabled on a port attached to only one multicast subscriber to avoid
disrupting services to other group members attached to the same
interface.
Immediate leave does not apply to multicast groups which have been
◆
statically assigned to a port with the
E
XAMPLE
The following enables immediate leave on a receiver port.
Console(config)#interface ethernet 1/5
Console(config-if)#mvr domain 1 immediate-leave
Console(config-if)#
This command configures an interface as an MVR receiver or source port.

mvr type

Use the no form to restore the default settings.
S
YNTAX
[no] mvr [domain domain-id] type {receiver | source}
domain-id - An independent multicast domain. (Range: 1-5)
receiver - Configures the interface as a subscriber port that can
receive multicast data.
source - Configures the interface as an uplink port that can send
and receive multicast data for the configured multicast groups.
D S
EFAULT ETTING
The port type is not defined.
C M
OMMAND
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND
A port which is not configured as an MVR receiver or source port can
◆
use IGMP snooping to join or leave multicast groups using the standard
rules for multicast filtering.
C
ODE
SAGE
ODE
SAGE
– 1267 –
| Multicast Filtering Commands
39
HAPTER
mvr vlan group command.
MVR for IPv4