Powering On A Sun Disk Shelf - Oracle ZS5 SERIES Installation Manual

Powering On a Sun Disk Shelf

Ensure that the power source is easily accessible because the power cord is the main
■
disconnect device for the disk shelf.
1. Plug a power cord into each power supply with fan module.
2. Plug the other end of the power cords into the external power source for the
cabinet.
Note -
independent power sources.
3. Supply power to the external power source.
4. Place the power supply on/off switches to the "I" on position.
Turn on the cabinet circuit breakers, if applicable.
5.
After the disk shelf powers on, which could take several minutes, ensure that
6.
the system power indicator on the front of the disk shelf is lit a steady green,
and that each power supply with fan module status indicator on the rear is lit a
steady green.
If not, reseat the faulted module after powering off the disk shelf as described in
a Disk Shelf" on page
reinsertion and powering on, contact Oracle Customer Service.
Related Topics
"Powering Off a Disk Shelf" on page 180
■
"Powering Off a Controller" on page 180
■
Powering On a Sun Disk Shelf
Use the following procedure to power on a Sun Disk Shelf.
Ensure you have met the following electrical safety measures before applying power to the disk
Before You Begin
shelf:
Provide a suitable power source with electrical overload protection to meet the power
■
supply input voltage range of 100-240 VAC, 50-60 Hz. The disk shelves are compatible
with 100-120 VAC or 200-240 VAC sources. The power source must not be overloaded
178 Oracle ZFS Storage Appliance Installation Guide • December 2016
To guarantee redundancy, power cords must be connected to two separate and
180. If the module status indicator is not a steady green after module
"Powering Off