Table of Contents
Advertisement
a.
Remove each flat cable cover by lifting up on the cable cover handle.
b.
Open it 180 degrees to the horizontal position.
c.
Apply upward pressure to the outside edge of each hinge connector until the
hinge connector comes off the hinge.
d.
Position each round cable cover horizontally over the hinges, and align the
hinge connectors with the hinges.
Using your thumb, apply downward pressure on each hinge connector to
e.
snap the hinge connector into place.
Installing a ZS5-2 Cable Management Arm
Installing a ZS5-2 Controller
117
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ZS5 SERIES and is the answer not in the manual?