Rip Filter - Funkwerk R1202 Reference Manual

15 Routing Protocols
232
Field
Route Announce

15.1.2 RIP Filter

In this menu, you can specify exactly which routes are to be exported or imported.
You can use the following strategies for this:
• You explicitly deactivate the import or export of certain routes. The import or export of all
other routes that are not listed is still allowed.
• You explicitly activate the import or export of certain routes. In this case, you must also
explicitly deactivate the import or export of all other routes. This is achieved using a filter
for IP Address / Netmask = no entry (this corresponds to IP address 0.0.0.0 with net-
mask 0.0.0.0). To make sure this filter is used last, it must be placed at the lowest posi-
Funkwerk Enterprise Communications GmbH
Description
• (default value): RIP is not enabled.
• : Enables sending and receiving of version 1 RIP
packets.
• : Enables sending and receiving of version 2 RIP
packets.
• :Enables sending and receiving RIP packets of
both version 1 and 2.
• : RIP V1 messages are sent, received
and processed as per RFC 2091 (triggered RIP).
• : RIP V2 messages are sent, received
and processed as per RFC 2091 (triggered RIP).
Select this option if you want to set the time at which any activ-
ated routing protocols (e.g. RIP) are to propagate the IP routes
defined for this interface.
Note: This setting does not affect the interface-specific RIP con-
figuration mentioned above.
Possible values:
• (not for LAN interfaces, interfaces in Bridge
mode and interfaces for leased lines): Routes are propagated
if the interface status is up or ready.
• (default value): Routes are only propagated if the
interface status is up.
• : Routes are always propagated independently of op-
erational status.
bintec Rxxx2/RTxxx2