Rip Filter - Funkwerk TR200aw User Manual

Funkwerk Enterprise Communications GmbH
funkwerk TR200aw/bw
Field
Receive Version
Route Announce

10.3.2 RIP Filter

In this menu, you can specify exactly which routes are to be exported or imported.
You can use the following strategies for this:
• You explicitly deactivate the import or export of certain routes. The import or export of all
other routes that are not listed is still allowed.
• You explicitly activate the import or export of certain routes. In this case, you must also
Description
Decide whether routes are to be imported via RIP and if so, se-
lect the RIP version for receiving RIP packets over the interface
in receive direction.
Possible values:
• (default value) RIP is not enabled.
• : Enables sending and receiving of version 1 RIP
packets.
• : Enables sending and receiving of version 2 RIP
packets.
• : Enables sending and receiving of both version 1
and version 2 RIP packets.
• : RIP V1 messages are sent, received
and processed as per RFC 2091 (triggered RIP).
• : RIP V2 messages are sent, received
and processed as per RFC 2091 (triggered RIP).
Select this option if you want to set the time at which any activ-
ated routing protocols (e.g. RIP) are to propagate the IP routes
defined for this interface.
Note: This setting does not affect the interface-specific RIP con-
figuration mentioned above.
Possible values:
• (default value): Routes are only propagated if the
interface status is up.
• : Routes are always propagated independent of oper-
ational status.
10 Routing
175