Controller Configuration - Funkwerk R1202 Reference Manual

Funkwerk Enterprise Communications GmbH
bintec Rxxx2/RTxxx2
In the case of manual channel selection, please make sure first that the APs actually sup-
port these channels.
Transmit Power
Displays the transmission power in dBm. You can select another transmission power.
With OK you take over the setting in window Access Point Settings.
Select the access points that your WLAN controller shall manage. In the Manage column,
click on the desired entries or click on Select all in order to select all entries.
Click on Start in order to install the WLAN and automatically assign the frequencies.
Note: If there are not enough licences available, the message "The maximum number of
slave access points that can be supported has been exceeded". Please check your li-
cences. If this message is displayed then you should obtain additional licences if appropri-
ate.
During the installation of the WLAN and the allocation of frequencies, on the messages dis-
played you will see how far the installation has progressed. The display is continuously up-
dated.
Provided that non-overlapping wireless channels are located for all access points, the con-
figuration that is set in the Wizard is transferred to the access points.
When the installation is complete, you will see a list of the Managed access points.

13.2 Controller Configuration

In this menu, you make the basic settings for the wireless LAN controller.
13 Wireless LAN Controller
161