Funkwerk R1202 Reference Manual page 248

15 Routing Protocols
234
Field
Interface
IP Address / Netmask
Direction
Metric Offset for Active
Interfaces
Metric Offset for Inact-
ive Interfaces
Funkwerk Enterprise Communications GmbH
Description
Select the interface to which the rule to be configured applies.
Enter the IP address and netmask to which the rule is to be ap-
plied. This address can be in the LAN or WAN.
The rules for incoming and outgoing RIP packets (import or ex-
port) for the same IP address must be separately configured.
You can enter individual host addresses or network addresses.
Select whether the filter applies to the export or import of routes.
Possible values:
• (default value)
•
Select the value to be added to the route metric if the status of
the interface is "up". During export, the value is added to the ex-
ported metric if the interface status is "up".
Possible values are to
The default value is .
Select the value to be added to the route metric if the status of
the interface is "dormant". During export, the value is added to
the exported metric if the interface status is "dormant".
Possible values are to
The default value is .
.
.
bintec Rxxx2/RTxxx2