Basic Settings; Radio Profile; Wireless Networks - Funkwerk R1202 Reference Manual

Funkwerk Enterprise Communications GmbH
bintec Rxxx2/RTxxx2

13.1.1 Basic Settings

Here you can configure all of the various settings that you require for the actual wireless
LAN controller.
The wireless LAN controller uses the following settings:
Region
Select the country in which the wireless controller is to be operated.
Note: The range of channels that can be used varies depending on the country setting.
Interface
Select the interface to be used for the wireless controller.
DHCP Server
Select whether an external DHCP server shall assign IP addresses to the APs or if your
device should be used as the DHCP server. For an internal DHCP server, CAPWAP option
138 is enabled in order to allow communication between the master and slaves.
Note: Make sure that option 138 is enabled when using an external DHCP server.
If you wish to use a bintec Gateway for example as a DHCP server, click on the FCI menu
of this device under Local Services->DHCP Server->DHCP Pool->New->Advanced Set-
tings in the DHCP Optionsfield on the Add button. Select as Option
and in the Value field enter the IP address of the WLAN controller.
IP Address Range
If the IP addresses are to be assigned internally, you must enter the start and end IP ad-
dress of the desired range.
Note: If you click on Next, a warning appears which informs you that continuing will over-
write the wireless LAN controller configuration. By clicking on OK you signal that you agree
with this and wish to continue with the configuration.

13.1.2 Radio Profile

Select which frequency band your WLAN controller shall use.
If the
If the
is set then the 2.4 GHz frequency band is used.
is set then the 5 GHz frequency band is used.
13 Wireless LAN Controller
157