Funkwerk R1202 Reference Manual page 250

15 Routing Protocols
236
Field
RFC 2453 Variable
Timer
RFC 2091 Variable
Timer
Fields in the Timer for RIP V2 (RFC 2453) menu
Field
Update Timer
Route Timeout
Funkwerk Enterprise Communications GmbH
Description
(="Network is not reachable").
The function is enabled with
The function is disabled by default.
For the timers described in RFC 2453, select whether the same
values that you can configure in the Timer for RIP V2 (RFC
2453) menu should be used.
The function is enabled with
The function is enabled by default.
If you deactivate the function, the times defined in RFC are re-
tained for the timeouts.
For the timers described in RFC 2091, select whether the same
values that you can configure in the Timer for Triggered RIP
(RFC 2091) menu should be used.
The function is enabled with
The function is disabled by default.
If the function is not activated, the times defined in RFC are re-
tained for the timeouts.
Description
Only for RFC 2453 Variable Timer =
An RIP update is sent on expiry of this period of time.
The default value is (seconds).
Only for RFC 2453 Variable Timer =
After the last update of a route, the route time is active.
After timeout, the route is deactivated and the Garbage Collec-
tion Timer is started.
The default value is (seconds).
.
.
.
bintec Rxxx2/RTxxx2