Funkwerk R1202 Reference Manual page 65

Funkwerk Enterprise Communications GmbH
bintec Rxxx2/RTxxx2
see Logging in on page 54).
(2) Enter for the input prompt. You are now in the Flash Management shell.
(3) Call up a list of all the files saved on the device:
If you see a display like the one below, the keys needed are already there and you can
connect to the device via SSH:
Note
The device generates a key pair for each of the algorithms (RSA and DSA), i.e. two
files must be stored in the flash for each algorithm (see example at above).
If no keys are available, you have to generate these first. Proceed as follows:
(1) Leave the Flash Management shell with
(2) Call the Funkwerk Configuration Interface and log on to your device (see
the Funkwerk Configuration Interface
(3) Make sure that
(4) Check the key status in the System Management->Administrative Access->SSH
menu. If both keys are available, you'll see in both fields RSA Key Status and DSA
Key Status the value
(5) If one or both of these fields contains the value
the relevant key. To have the device generate the key, click Generate.
The device generates the corresponding key and stores it in the FlashROM.
indicates successful generation.
(6) Make sure that both keys have been successfully generated. If necessary, repeat the
procedure described above.
.
on page 58).
is selected as the language.
8 Access and configuration
.
Calling
, you must generate
51