Funkwerk R1202 Reference Manual page 179

Funkwerk Enterprise Communications GmbH
bintec Rxxx2/RTxxx2
ated again but shall not be configured.
Wireless LAN Controller
Fig. 63:
In the menu Wireless LAN Controller->Slave AP configuration->Slave Access Points-
> the data for wireless module 1 and wireless module 2 are displayed, if the correspond-
ing device contains two wireless modules. With devices featuring a single wireless module,
the data for wireless module 1 are displayed.
This menu consists of the following fields:
Fields in the Access Point Settings menu
Field
Administration Status
CAPWAP Encryption
Slave AP configuration
->
Description
Select whether the selected AP is to be managed from the
WLAN controller.
The function is activated by selecting
The function is enabled by default.
You can disconnect the AP from the WLAN controller and there-
fore remove it from your WLAN infrastructure by disabling the
function. The AP then receives the
no longer .
Select whether communication between the master and slaves
is to be encrypted.
13 Wireless LAN Controller
Slave Access Points
-> ->
.
status, but is
165