Funkwerk R1202 Reference Manual page 81

Funkwerk Enterprise Communications GmbH
bintec Rxxx2/RTxxx2
8.3.1.3 Funkwerk Configuration Interface menus
The configuration options of your device are contained in the sub-menus, which are dis-
played in the navigation bar in the left-hand part of the window.
Note
Please note that not all devices have the full range of functions. Check the software of
your device on the corresponding product page under
The Funkwerk Configuration Interface contains the following menus:
Assistants
Menu
First steps
Internet Access
VPN
SWYX
VoIP PBX in LAN
System Management
Menu
Status
Global Settings
Function
In this menu you can make the basic settings that are required
to add your gateway to your local network (LAN).
The wizard guides you through the individual configuration
steps to connect your local network (LAN) to the internet.
In this menu you are guided through all of the settings that are
required to set up your LAN-LAN connection as a virtual private
network.
In this menu, you can configure the settings required to connect
your device to the SWYX SIP server. In this case, your device
acts as a SIP client.
The assistant is required, e.g. for specific PBX in the LAN, such
as Hybird in order to guarantee SIP compatibility. To do this,
external communication is carried out over a single IP address
and NAT is realised as full-cone NAT.
Function
In this menu, general information on your device is displayed at
a glance.
This information includes serial number, software version, cur-
rent memory and processor use, status of the physical inter-
faces and the last 10 system messages.
In this menu, you enter the basic system settings of your device,
8 Access and configuration
www.funkwerk-ec.com .
67