Table of Contents
Advertisement
Connecting the power cord
CAUTION:
Before powering on the switch, you must connect the power cord and make sure the switch is well
grounded.
Follow these steps to connect an AC power cord:
1.
Wear an ESD-preventive wrist strap, and make sure the wrist strap makes good skin contact and
is well grounded.
Insert the plug of the AC power cord into the AC power receptacle (see
2.
3.
Connect the other end of the AC power cord to the AC power source.
4.
Check the power LED (PWR) on the front panel. If the LED is on, the power cord is properly
connected.
Figure 15 Connect the AC power cord
Verifying the installation
After you complete the installation, verify that:
There is enough space for heat dissipation around the switch, and the rack or workbench is stable.
•
•
The grounding cable is securely connected.
The correct power source is used.
•
The power cords are properly connected.
•
All the interface cables are cabled indoors. If any cable is routed outdoors, verify that the socket
•
strip with lightning protection and lightning arresters for network ports have been properly
connected.
13
Figure
15).
Advertisement
Table of Contents
