Setting Network Addresses Via A Serial Connection; Connecting The Serial Cable - HP StorageWorks 2/16 - SAN Switch Installation Manual

Installing the SAN Switch 2/16

Setting Network Addresses via a Serial Connection

Use the following procedure to verify or change the switch IP address,
subnetmask, or gateway address.
Note:
gateway addresses with addresses provided by your network administrator.
1. Remove the shipping plug from the Serial port.
2. Connect the Serial cable to the Serial port, see
Figure 14: Connecting the Serial cable
3. Connect the other end of the Serial cable to an RS-232 Serial port on the
4. Verify that the switch power is on and POST is completed. See the
5. Power on the workstation and establish a connection to the switch using a
40
During first-time setup, you must replace the factory IP, subnetmask, and
workstation. If no RS-232 Serial port is available on the workstation, the
adapter on the end of the Serial cable can be removed to use the RJ-45
connector to create a Serial connection.
Self Test" on page 38.
terminal emulator application (such as HyperTerminal).
Figure 14.
SAN Switch 2/16 Version 3.1.2 Installation Guide
SHR-2551A
"Power-On