Table of Contents
Advertisement
Configuring SAN Switch 2/8 Network Addressing
Read the following sections for information on how to configure the SAN Switch
2/8 addressing scheme.
Requirements
The following items are required to set network addressing.
Setting Network Addresses via a Serial Connection
Use the following steps to verify or change the SAN Switch 2/8 IP address,
subnetmask, or gateway address.
Note:
addresses with addresses provided by your Network Administrator.
1. Remove the shipping plug from the SAN Switch 2/8 Serial port.
hp StorageWorks SAN Switch 2/8 Installation Guide
An IP address from your Network Administrator
SAN Switch 2/8 installed and connected to a power source
Serial cable (supplied with the switch) for connecting the switch to the
workstation
A local workstation (desktop or notebook computer) with:
®
— Microsoft
Windows 98, Windows 2000, Windows Millennium Edition,
or Windows NT 4.0 operating system
— RS-232 serial communication software (for example, ProComm Plus or
HyperTerminal)
Ethernet cable for connecting the switch to the workstation or to a network
containing the workstation
SFPs and cables, as required to connect the switch to the fabric
During first time setup, you must replace the factory IP, subnetmask and gateway
Installing the SAN Switch 2/8
47
Advertisement
Table of Contents
