Setting Network Addresses - HP StorageWorks MSA 2/8 - SAN Switch Installation Manual

Configuring the MSA SAN Switch 2/8

Setting Network Addresses

Use the following steps to enter the MSA SAN Switch IP address, subnetmask,
and gateway address.
Note:
gateway address with addresses provided by your Network Administrator.
1. Log on to the switch using the admin log on.
2. Enter the following command at the prompt:
3. Enter the information at the prompts, as listed below:
Note:
4. Verify that the information was entered correctly by entering:
View the display to confirm the settings.
34
During first time setup, you must replace the factory IP address, subnetmask and
See "Accessing the CLI" for instructions.
ipAddrSet
Press Enter to pass over a prompt and accept the default value.
— Ethernet IP Address [10.77.77.77]:
Enter the new ethernet IP address.
— Ethernet subnetmask [255.255.255.0]:
Enter the new ethernet subnetmask.
— Fibre Channel IP Address [none]:
Enter the new Fibre Channel IP address if desired.
— Fibre Channel subnetmask [none]:
Enter the new fibre channel subnetmask if desired.
— Gateway Address [none]:
Enter the new gateway address.
— Set IP address now? [y = set now, n = next
reboot]:
Enter y to set now.
ipAddrShow
MSA SAN Switch 2/8 Installation Guide