Table of Contents
Advertisement
Figure2-7 HPE 5944 48XGT 6QS28 chassis dimensions with the mounting brackets installed
at the power supply side
(1) Power supply handle
Follow these guidelines when you install the switch in a 19-inch rack:
•
The distance between the front and rear posts of the rack must meet the requirements
described in Table2-3.
•
To secure the switch to the rack, you must install not only mounting brackets, but also chassis
rails and slide rails.
Table2-3 Distance requirements between the front and rear rack posts
Switch model
HPE 5944 48XGT
6QS28
Table2-4 Chassis dimensions and rack depth requirements
Device
model
HPE 5944
48XGT
6QS28
Attaching the mounting brackets, chassis rails, and
grounding cable to the chassis
The switch has two mounting bracket installation positions on its two side panels: one near the
network port side and one near the power supply side.
The switch provides a primary grounding point (with a grounding sign) and an auxiliary grounding
point.
Figure2-8
describes these positions on the HPE 5944 48XGT 6QS28 switch.
Installation method
Using mounting brackets and rack
mounting rail kit A (long slide rails)
Using mounting brackets and rack
mounting rail kit B
Chassis dimensions
•
Height—44 mm (1.73 in) (1 RU)
•
Width—440 mm (17.32 in).
•
Total depth—485 mm (19.09 in)
25 mm (0.98 in) for the power
supply or fan module handle
460 mm (18.11 in) for the
chassis.
(2) Mounting bracket
Distance between the front and
rear rack posts
621 mm to 854 mm (24.45 in to 33.62 in)
401 mm to 634 mm (15.79 in to 24.96 in)
Rack depth requirement
To ensure that the rack door can be closed
easily after cables are connected, make sure
the rack meets the following requirements:
•
A minimum of 800 mm (31.50 in) in depth
(recommended)
•
A minimum of 130 mm (5.12 in) from the
front rack post to the front door
•
A minimum of 509 mm (20.04 in) from
the front rack post to the rear door
2-9
Advertisement
Table of Contents
