Attaching The Clip Nuts-For Rails With Round Holes; Attaching The Upper Rack Mount Bracket Assemblies To The Chassis - HP StorageWorks 2/64 - Core Switch Installation Manual

Attaching the clip nuts—for rails with round holes
If you are installing the 14U Rack Mount Kit in rails with round holes, use the instructions in this
section. Attach the clip nuts to the vertical rails on the service side of the rack as follows.
1. Count up 41 round holes from the 1U location.
2. Attach the four clip nuts to the two rails at the front of the rack (service aisle side). See
Figure 6.
NOTE: Cables can be routed down through the cable management tray or through the holes
in the sides of the chassis. If the cables will be routed down through the cable management
tray, allow adequate space below the chassis for cable management.

Attaching the upper rack mount bracket assemblies to the chassis

Use these steps to attach the upper rack mount brackets to the chassis. The upper rack mount
bracket assemblies consist of the following:
• One right flat upper rack mount bracket attached to an L-shaped bracket
• One left flat upper rack mount bracket attached to an L-shaped bracket
NOTE: To compete this procedure, you must first detach the L-shaped brackets from the upper
rack mount bracket assemblies.
1. Use a Phillips head screwdriver to remove the screws securing the left and right upper rack
mount brackets to the L-shaped brackets. Detach the L-shaped brackets from the assembly
and put them aside.
NOTE: You reinstall the L-shaped brackets to the rack rails in
2. Save the screws for attaching the bracket assemblies to the chassis (see
"Securing the chassis to the
3. Use four #10-32 x 5/16 inch screws to secure the right and left flat upper rack mount
brackets to the chassis. See
NOTE: Orient the slotted holes in the brackets toward the blower side of the chassis (see
Figure 7 for orientation).
38 Installing and configuring the switch
rails" on page 41).
Figure 7.
step 5.
step 1 in the section