Table of Contents
Advertisement
6.
Holding the power supply handle with one hand and, supporting the bottom of the power supply
with the other, gently pull the power supply out, as shown in callout 2 on
7.
Put the removed power supply on the antistatic mat.
8.
Install a new power supply. For the installation procedures, see
Figure 37 Removing the power supply
(1) Loosen the captive screw
Replacing a card
The replacement procedures of the cards on the HP FlexFabric 1 1900 switches are similar. Before you
replace a card, remove all its cables.
If no new card is to be installed, install a blank filler panel to ensure adequate ventilation and dust
prevention.
Replacing an MPU or LPU
The MPUs and the LPUs of 1 1908-V are installed in vertical slots, and the replacement procedures are the
same.
1
2
(2) Pull the power supply out
51
Figure
37.
"Installing
FRUs."
Advertisement
Table of Contents
Troubleshooting
