Director blade filler panel
This section describes how to remove and replace a Director blade filler panel (see
Removing a filler panel
CAUTION:
A filler panel should be removed only when being replaced with a Director blade, or new
filler panel. Any slot that is not occupied by a Director blade should be occupied by a filler panel to ensure
correct cooling of the chassis and protection from dust.
To remove a filler panel:
1.
Remove the chassis door. See
2.
Unscrew the thumb screw at the bottom of the panel using the Phillips screwdriver.
3.
Pull the filler panel out of the chassis (see
Replacing a filler panel
To replace a filler panel:
1.
Orient the filler panel (see
2.
Slide the filler panel into the slot until it is firmly seated.
3.
Tighten the thumb screw at the bottom of the panel.
4.
Replace the chassis door (see See
Figure 29
Director blade filler panel
"Removing the chassis
Figure
29).
Figure
29).
"Removing the chassis
DC SAN Backbone Director hardware reference guide
door" on page 64.
door" on page 64).
26395a
Figure
29).
69