Airspace - LXNAV LX80XX User Manual

Operating Modes
accidental removal of the media before files are fully written to it. Removal while files are
being written would result in corrupted files on the media.
4. Install latest version of the firmware on your device.
5. With SD/USB containing CIT files inserted into your device go to Setup->Password and
enter 00112. You will now be asked "Map (CIT) file(s) have been detected on external
media. Would you like to copy them to internal memory?" Press "Yes".
Copy procedure will begin and maps will be copied to internal memory. You will see an
estimation of time to finish (ETA) on your device. It may take up to an hour, so prepare
accordingly (enough battery, time).
After copying it should state 'OK' for all copied files. If it doesn't then it's likely that you have
a faulty CIT file on the external SD/USB media (return to step 3 or 2, if you suspect a faulty
download).
After exiting this dialog the device will automatically restart and when it starts again you can
verify installed and used maps in "About" dialog.
If you don't have enough space available and if you wish to have the CITv2, you
should contact LXNAV about the HW/memory upgrade.
5.1.6.2

Airspace

In this dialogue you can define the airspace map presentation. Check the Show airspace
item to enable airspace displays in navigational pages. If this item is unchecked no airspace
will be displayed.
If the Show inactive zones option is checked then airspace zones with proximity warning
switched off will be shown. Use Show only airspace below to eliminate airspace which is
going to be too high for the day. For example, if the forecasted cloud base is to be 1500 m,
set this value to 1600 m and your screen will be much more readable. In the Type panel
you can specify how each airspace type is displayed.
airspace zone separately. First choose an airspace type from the list. Zoom value defines
to which zoom level this type is going to be visible. The Colour and Width items specify
how selected airspace zone will be drawn. You can also modify transparency of the selected
You should define each type of
Page 54 of 192
Version 6.03, May 2017