LXNAV LX80XX User Manual page 169

Flying with the System
Ground speed and pressure altitude are also shown in the message. At the bottom two
buttons are displayed. Use the CLOSE button if this was not a valid start and you want to
remove the message from screen. If message is removed it will appear again next time you
leave the start zone. If you press the START button navigation will be advanced to the first
turning point.
There is no need to press START inside the start observation zone. You may
press it any time after leaving the start observation zone or crossing the start line.
The system will always take the correct time as start time.
If for some reason you miss the start message you may always start the task by pressing
the START button. Go to task mode and press any button. In the top row the START
button is shown. Press this button and navigation will be advanced to the next turn point.
In case you change the task in the air and you are already flying towards first turn point you
will still be able to start a task. Press the START button and a message dialogue to confirm
task start will be opened.
ARM button
You can enable this mode using Task Options dialog. In this mode you have to ARM start
prior to start. Before crossing start line or leaving start zone, press ARM button. Message
"Task armed!" will be displayed. ARM button will be changed to START button.
Page 169 of 192
Version 6.03, May 2017