Xpdr; Radio - LXNAV LX80XX User Manual

Navigational page layout
6.2.1.6

Xpdr

This dialog will be available only when 232 Bridge is installed and used as a transponder
bridge. In dialog current squawk, mode and flight level are displayed.
Use MODE to select mode of operation of connected transponder (STBY, GND, ON, ALT).
Press CODE to enter squawk code. Press VFR to automatically set squawk code to 7000.
Press IDENT to identify.
6.2.1.7

Radio

This dialog will be available only when 232 Bridge is installed and used as a radio bridge. In
dialog active and standby frequency are shown, transmit status and volume control are
shown.
Press SET FREQ button to swap active and standby frequency. Press SQ to toggle volume
control between volume, squelch and vox. Use upper left rotary knob to adjust it. In
HISTORY pull down menu, a list of recently used frequencies is stored. Press DUAL, when
available, to listen to active and standby frequency simultaneously. Press 8.33 KHz to
toggle between 25 KHz and 8.33 KHz channel spacing.
Page 144 of 192
Version 6.03, May 2017