LXNAV LX80XX User Manual page 84

Operating Modes
5.1.11.4.3 Numerical (navbox) Mode
Defaults are 4 NavBoxes: Average Vario, Netto, Altitude and True Airspeed. In addition, the
central line shows the status of the Flarm, GPS, Cruise/Climb and battery status.
MacCredy setting
Vario indicator
needle
Wind vector
Last thermal average
Needle type
Yellow Bar (Min/Max
vario or Min/Max g-
force
Red diamond
 The Vario Needle can display: the Vario, Netto, Relative or Speed to fly value
(Setup->Hardware->Indicator). The scale can be chosen in the range of +/-
5 +/-10 or +/-20 (in SETUP-> Vario Parameters). Within the software the
range can be set to m/s, kts, km/h, mph or fpm (in Setup, Units, Vertical
speed)
 The Speed to fly bar symbol indicates which speed you have to fly relative
to the current MacCready setting, sink rate and speed. One arrow means 10
units of speed faster or slower. Up red arrows mean fly slower and down
blue arrows mean fly faster. It can be also set to Flaps tape, / Speed tape
/ Flaps & Speed tape
 The Red diamond symbol can show Netto, Average Netto, Average vertical
speed or G-force.
 The Blue arrow symbol shows the current MacCready value.
 The Green T symbol represents last thermal average value.
 The Yellow Bar can show Max and Min values of vario over defined time
(average vario) or G meter (over whole flight).

The Flarm Status symbol indicates the presence of a Flarm unit (grey), if
the Flarm receives any data from other Flarm units, the symbol becomes red.
 The GPS symbol is green when GPS status id is OK, and red when GPS status
is bad. If GPS data is not detected, the symbol will disappear.
All these parameters can be set/adjusted on the LX80/90xx device at: SETUP->HARDWARE-
>"V8/V80/I8/I80" indicator SN:xxxxx.
Page 84 of 192
Version 6.03, May 2017
Upper selectable
navboxes
Flarm status
B
Climb/cruise
symbol
Speed to fly
Speed to fly bar /
symbol
Flaps tape/ Speed
tape/ Flaps &
Speed tape
Battery
B
GPS status
Lower selectable
navboxes
B
Range/units