Saving A Task; New Task (Task Creation) - LXNAV LX80XX User Manual

Operating Modes
The upper yellow number shows the current ground speed and the chevrons indicate if you
have to slow down or you may speed up.
In the picture above we are 118 meters above the glide to start altitude. Our speed is
111 km/h and the chevrons show that we can speed up.
Start speed and start altitude mode is available only if the Navigate to nearest
point is checked.
5.7.2.4

Saving a Task

Once a task is completed it could be saved to the active waypoint file. Press SAVE and the
"Task saved"
message
If the task already exists in the active waypoint file the message
shown.
5.7.3

NEW task (task creation)

Make sure that at least one waypoint file is loaded into the main display unit and that it is
checked and marked as an active waypoint file. Refer to Chapter 5.1.5.1 for details on how
to upload waypoint files to the system.
Select task time (if AAT taks) and press the EDIT button. Enter the task time if required
(AAT). Rotate the PAGE selector knob to increase time in 15 minute steps and the ZOOM
selector knob to increase task time in 1 minute steps. Close the task time edit and rotate
the PAGE selector knob to select the first empty point.
Press the EDIT button and enter a turn point name. Entering a point name is very straight-
forward. Enter the first letter of the task point name using the PAGE selector knob. The
"Helper" will show the first waypoint that matches this letter.
will appear on screen.
Page 130 of 192
Version 6.03, May 2017
"Task is already saved!"
is