Flap Sensor; Secondary Vario Indicators - LXNAV LX80XX User Manual

Options
For more detailed instructions on installation, please refer to installation manual.
®

10.6 Flap sensor

The flap encoder is connected to the system via the RS485 bus. It is physically mounted
near the flap mechanism. The flap encoder is very sensitive and accurate and can detect
very small movements.
Please refer to flap sensor manual for details about installation. For configuration on the
main display unit see Chapter 5.1.11.14.
For more detailed instructions on installation, please refer to installation manual.

10.7 Secondary Vario Indicators

An unlimited number of secondary vario indicators can be connected to the system bus.
RS485 splitting units should be used to extend the bus capacity.
secondary units depends on settings made in setup (see chapter 5.1.11.1.3).
Each unit has two female nine-pin connectors on the back side. Both connectors are 100%
pin to pin compatible and it doesn't matter which will be used.
operated unit can be any time connected to a free connector port of the vario indicator.
Page 190 of 192
Version 6.03, May 2017
The functionality of
Any other RS485 bus