Starts (Multiple Start Points); Zone (Modifying Zones) - LXNAV LX80XX User Manual

Operating Modes
 CLEAR will completely erase the task.
 MOVE UP is used to move selected point upwards within the task.
 MOVE DN is used to move selected point downwards within task.
5.7.2.1

Starts (Multiple start points)

On some competitions, multiple start points are used for start. Press STARTS button to
open multiple starts dialog.
First start point will be grey out. This is point, which is defined in task. Add as many start
points as required. Later it is possible to cycle through start points with CYCLE button.
5.7.2.2

Zone (modifying zones)

Select a point and press the ZONE button. A new dialogue with the observation zone for
the selected point will open.
Using parameters in the zone dialogue it is possible to describe all types of observation
zones. Angle12 defines the orientation of the observation zone. Available parameters for
Direction are:
 Symmetric: the most common selection for a turn point.
 Fixed: mostly used for assigned areas.
 Next: orients the observation zone in direction of the outgoing leg. This is usually used
for start.
Page 126 of 192
Version 6.03, May 2017