Table of Contents
Advertisement
TrafficView Version 1.00
TCAS layout looks like classic TCAS displays.
Active timeout adjusts remaining time for glider on map after last seen.
Inactive timeout adjusts remaining time of inactive gliders on the list. Inactive gliders are
gliders, which signal was lost, after Active timeout, they became inactive and remains only
on the list.
Line to selected target and selected waypoint can be enabled or disabled in this menu.
If glider vertical distance is less than 100m (330ft), then glider will be painted with near
glider colour. Gliders with vertical distances above that, will be painted with above setting
and below 100m (330ft) will be painted with below setting.
Zoom mode can be set to automatic (zoom to the target) or manual.
If Target label text is selected, near glider will display chosen value.
Lock on nearest automatically selects nearest target and displays its data. In case, that
you want to select another target, it's possible. After 10 seconds, TrafficView will
automatically switch back to nearest target.
If no target is selected Auto select will select to new incoming target. Lock on nearest
has higher priority.
If Draw history is enabled, paths of the Flarm objects will be seen on the screen for the
last 60 points.
The size of the plane and Flarm objects can be adjusted.
4.10.2.2
Airspace
In airspace setup user can globally enable showing airspace, do some adjustment to filter
airspace below selected altitude, define colour of each type of the airspace zone.
4.10.2.3
Waypoints
In waypoints setup user can globally enable showing waypoints, limit the maximum
number of visible waypoints and set zoom level up to which we will display the name
of the waypoint.
4.10.2.4
Theme
Dark and Light theme is available and can be switched here.
4.10.2.5
Modes
If we want to skip some modes from the main screen, we can do that in this setup menu.
At the moment only task and waypoint mode can be hidden.
Page 14 of 22
August 2019
Advertisement
Table of Contents
