Map Edit Mode; Thermal Mode - LXNAV LX80XX User Manual

Operating Modes Version 6.03, May 2017
5.7.5.2

Map edit mode

In map mode, it is possible to create task on map. Use MODE selector knob to move grey
cross left or right and PAGE selector knob to move up and down. Turn ZOOM selector knob
to zoom.
Move cross to task point to pick it and move it around. Move cross to task leg to insert
point.

5.8 Thermal Mode

System can automatically switch to thermal mode. When glider enters thermal, device will
switch to thermal page and zoom will adjust according to settings set in the following
chapter: 5.1.6.5.
There can be only one page set as thermal for airport mode, waypoint mode and task mode.
You can change current page to thermal mode in layout settings described in chapter
6.3.25.
In this dialog you can enable it and also change track length, colouring of line and zoom of
map when in thermal mode.
Previous navigational page will be restored when your aircraft will stop circling. You can also
manually exit thermal mode by rotating PAGE or ZOOM knobs.
Page 134 of 192