Interfaces; Internal Options - LXNAV LX80XX User Manual

Basics
 3.5'' (8.8 cm) sunlight readable screen with 1200nits
 QVGA (320*240pixels) sunlight readable display
 ARM Cortex-M4 processor running on 160MHz

Digital temperature compensated pressure sensors for altitude and airspeed
 inertial platform 3 axis digital +-6g accelerometer, 4 gyroscopes (for inertial vario, AHRS
and wind calculation)
 Smooth audio output with audio equalizer and many custom audio settings
 integrated synthesized speech output
 audible thermal assistant
 External SD card for configuration, FlarmNet and firmware update
 Push buttons for setting adjustments
 ALS (ambient light sensor)
 Additional Flarm radar screen and artificial horizon (optional).
 Three buttons for toggling between screen and target selection

digital temperature compensated pressure sensors for altitude and airspeed
 100Hz sampling rate for very fast response.
 Speed to fly indication.
TE compensation can be selected to be either pneumatic TE probe or digital compensation.
2.1.5

Interfaces

 The RS232 interface has NMEA output for external devices.
 An SD Card interface.
 A USB slot for data transfer using USB memory stick.
2.1.6

Internal Options

Flarm module can be built into the main display unit.
available on the rear side of the unit (Flarm external indicator, Flarm antenna), which
guaranties the same comfort as with the original Flarm devices. It is very important to point
out that the whole system uses only one GPS receiver and therefore offers a low power
solution.
Artificial horizon can be enabled on main display unit. Vario sensor box is constantly
using data from inertial platform in order to make vario signal smoother, however if pilot
would like to see artificial horizon and software option to do so must be purchased.
Page 12 of 192
Version 6.03, May 2017
All necessary connectors are