Installation; Compass - LXNAV LX80XX User Manual

Options

10.4.2 Installation

For more detailed instructions on installation, please refer to installation manual.
Remote stick is connected to RS485 bus through RS485 splitter. Be careful to connect
correct coloured wire to pin, which is marked with same colour.
PTT wires are connected to radio push to talk input and SC wire is connected to Speed to fly
input of vario unit.
Do not forget to set the speed command input setting to TASTER (see
Chapter 5.1.11.1).
After installation there is no special setting required on main display unit as the
remote stick will be automatically detected.

10.5 Compass

Compass module must be connected to RS485 bus. It must be installed to the place where
is no strong magnetic fields (Irons or ferromagnetic materials), cables with AC current or not
constant DC currents.
When installing magnetic compass use screws made of non-ferromagnetic
materials (plastic or brass)
Orientation of compass module marked on housing as on picture above.
Page 189 of 192
Version 6.03, May 2017