Flywheel And Clutch Disc; Fnspection/Removal - Honda Prelude 1993 Service Manual

Flywheel
Inspection/Removal
Flywheel and Clutch Disc
CLUTCH DISC
lnstallation
.-Align the hole in the flywheel with the crankshsft
dowel pin and assemble. Install the mounting bolts
only tinger tight.
Install the special tool. then torque the mounting
b o l t s i n d c r i s s c r o s s p a t t e r n i n s e v e r a l s t e p s a s
shown.
07LAB - PV00100 or MOUNTTNG
BOLTS
07924 - PD2fi)O3
tO5 N.rn tj9.5 k,-m, ?G tb-ft1
I n s t a l l t h e c l u t c h d i s c u s i n g t h e s p e c i a l t o o l s a s
shown.
HANDI.I
07936 - 3710100
CLUTCH ALIGNMENT
SHAFT
07LAF - PT|X)I10
l "
1 ,
2.
Inspect the ring gear teeth for wear and damage,
Inspect the clutch disc mating surface on the fly-
wheel for wear, cracks, Snd burning.
Measure the flywheel runout using a disl indicator
through at least two full turns. Push the flywheel
towards the engine to take up the crankshaft thrust
washer clearance.
N O T E : T h e r u n o u t c a n b e m e a s u r e d w i t h e n g i n e
installed.
Standard lNowl: 0.05 mm {0.002 in) mrx.
Service Limit 0.15 mm {0.(X)6 in)
lf the runout exceeds the service lirnit, reDlace the
flywheel.
rLvwxeel (}
4 .
R e m o v e t h e e i g h t f l y w h e e l m o u n t i n g b o l t s i n a
crisscross pattern in ssveral steps, and remove the
flywheel.
FLYWHEEL
RII{G GEAR HOLDER
o?LAB - PVO010O ol
0?924 - PD2o003
FLYWHEEL
FLY\AIHEEL
(P/N 08798 - 9002)