Configure General Sip Parameters - AudioCodes Mediant 500 Quick Manual

Quick Guide
5.3

Configure General SIP Parameters

This step identifies the device configuration needed to support the SIP General Parameters
configuration.
5.3.1 Configure SIP General Settings
This step shows how to configure the SIP General Settings.

To configure the SIP General Settings parameters:
1. Open the SIP Proxy & Registration Parameters page (Setup menu > Signaling &
Media tab > SIP Definitions folder > SIP Definitions General Settings).
2. Configure following parameters:
Gateway Settings
Source Header For Called Number
Gateway Session Expires
Session Expires Method
Disconnect Supervision
Broken Connection Mode
Figure 5-7: Configuring SIP General Settings Parameters
3. Click Apply.
Version 7.2
Parameter
19
Value
Use To header
Update
Ignore
AudioCodes Mediant Gateway
5. Configure Device