Step 6: Configure Trunk Group - AudioCodes Mediant 1000B Configuration Note
And avaya aura messaging with nortel cs1000 using t1 qsig
Hide thumbs
Also See for Mediant 1000B:
- User manual (1281 pages) ,
- Hardware installation manual (92 pages) ,
- Quick setup manual (8 pages)
Table of Contents
Advertisement
5.8
Step 6: Configure Trunk Group
This step describes how to configure the Trunk group.
To configure the Trunk group:
1.
Open the 'Trunk Group Table' page (Configuration Tab: VoIP > GW and IP to IP >
Trunk Group > Trunk Group).
3.
Match the 'Phone Number' field with the pilot number of the QSIG trunk.
4.
If more than one trunk is used, in the 'To Trunk' field, enter the last trunk number (e.g.,
2) pertaining to the Trunk Group and then in the 'Channel' field, enter the number of
channels (e.g., 1-48) accordingly.
5.
Click Submit.
Configuration Note
Figure 5-7: Trunk Group Table
22
Avaya Aura Messaging & Nortel CS1000
Document #: LTRT-12470
Advertisement
Table of Contents
