Operating The Display - GRAUPNER mz-24 Pro Programming Manual

Operating the display

The display is basically operated by touching the de-
sired fi eld with a fi nger or the provided stylus:
000%
000:00.0
000 000
mz
0:01:23 000:00.0
M - 1
000 000
PHASE 1
MODELLNAME 1
BATT TIME 00: 01: 23
000
By touching the model memory fi eld labeled "M 1" in
the above display with a fi nger or the provided stylus,
the "Model memory" selection menu opens.
BACK MODEL NAME 1
01 MODEL NAME 1
02 MODEL NAME 2
MODEL NAME 3
03
04 MODEL NAME 4
05 MODEL NAME 5
06 MODEL NAME 6
In this sub-menu, you have the possibility for example
to change the model memory by touching the desired
SEL
model memory and then the button.
Just as described on page , touch
gramming a Programming a new model
MODEL NAME 1
the fi eld at the upper edge of the
display to switch to the "Model name" entry menu,
BACK
or touch at the top left to return to the pre-
vious menu item. In contrast, touch the button
[Change page] (generally using the rotation method)
which is also available in several menus to go to the
next page. In the above display of the model memory,
this would be to the display of model memories 07 ...
12, etc.
6 Operating the displays
Touching one of the three gear icons identifi ed with
"B", "F", and "S", special selection menus open on
the bottom right from which you can switch to other
000%
sub-menus. Starting with the green BASE menu, the
4.2V
selection displays appear as follows, ...
000
... it should be noted that the blue function menu de-
NEXT
scribed from page 120, Function menu contains
SEL
model-type-specifi c sub-menus and for this reason in
NEW
divided into a total of three paragraphs.
IMP.M
In the fi rst paragraph starting on page
EXP.M
sub-menus for "Vehicles", "Copters" and "Boats"
RES
model types will be described. Because the same
CPY
sub-menus are also included in the "blue" menus of
the model type "Helicopter" and "Fixed-wing" mod-
els, their description is valid for all the model types
and for space reasons they will not be repeated in
both other paragraphs:
NEW to start pro-
, or touch
SW
In the second paragraph, beginning on page 154,
exclusively the sub-menus related to the model type
"Helicopter" will be described excluding the above
mentioned "general menus":
BACK BASE FUNCTION SYSTEM
Model Type
Model Sel E.P.A REV/SIB Motor
TX ctl Timer Fail Safe Trim Step Servo
CTL Set Out.Swap Telemetry Announce
120 only the
BACK BASE FUNCTION SYSTEM
Trainer
Phase D/R,EXP THR.CRV Prog.MIX
Logical sw Sequence
BACK BASE FUNCTION
Phase D/R,EXP PIT.CRV THR.CRV
THR.HOLD Swash S.Limit S.MIX
Prog.MIX Trainer PIT>>TAIL Logical sw
And in the third paragraph, beginning on page
also excluding the previously described "general
menus", exclusively the sub-menus related to the
"fi xed-wing" model type, in which the menus of a
"motor powered model" ...
BACK BASE FUNCTION
Phase D/R,EXPO THR.CRV Idle LOW
Snap roll Aile diff Wing MIX Flap MIX
Airbrake TTrainer Logical sw Sequence
... distinguishes from the menus of a "Glider" model:
BACK BASE FUNCTION
Phase D/R,EXP THR.CRV Prog.MIX
Aile diff Wing MIX Flap MIX Flap set
Trainer Logical sw Sequence V-Tail
The purple System menu which can be accessed
tapping on "S" and whose description begins on page
220, is displayed as follows ...
SYSTEM
Gyr/Gover
THR.MIX
Sequence
182
SYSTEM
Prog.MIX
Flap set
V-Tail
SYSTEM
Snap roll
Butterfly