General Operating Instructions - GRAUPNER X-8N Manual

4 channel hott radio control
Hide thumbs Also See for X-8N:
Table of Contents

Advertisement

Information on handling the transmitter
Attention!
!
Also while programming the transmitter, make sure that a connected motor cannot accidentally start. Disconnect the fuel

supply or drive battery beforehand.
Risk of fire! Avoid every kind of short-circuit in all sockets of the transmitter! Use only the suitable connectors. In no case

the electronic component of the transmitter may be changed or modified. Due to licensing reasons, any reconstruction and/or
modification of the product is prohibited.
During transport protect the model and the transmitter from damages.


General operating instructions

Method for Installation of Receiver
The receiver is to be installed with a foam rubber cushion to afford protection against jarring, in air-
craft models behind a strong rib and in a car or ship model in a place where it is protected against
dust and spray water. The receiver may not be mounted in direct contact with the hull or chassis as
this would allow motor vibrations and/or landing jolts to be transferred directly to the receiver. When a
receiver system is installed in a model with a combustion motor, all receiver parts should be installed
so as to prevent exhaust gases and oil residues from infiltrating. This especially applies to the ON/
OFF switch, which is usually built into the model's outside skin. Position the receiver such that con-
necting cables to the servos and the power supply are routed with a bit of slack
and that the receiver's antenna is at least 5 cm away from any large metal parts or wiring other than
those proceeding from the receiver. In addition to steel, this also applies to carbon fiber parts, servos,
electric motors, fuel pumps, any kind of cable and similar items. Optimally the receiver should be
placed at a readily accessible location that is well away from all other equipment. Under no circum-
stances may a servo cable be wrapped around the antenna or routed close to it.
Ensure that cables near the antenna cannot move about during flight.
8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents