GRAUPNER mz-24 Pro Programming Manual page 228

charge of the power source connected to the module
at the battery connection.
Notice
To correctly display the data, the charge must be
entered beforehand in the "Telemetry" menu.
2. Display
The two graphics to the left show the current voltage
measured by the temperature and voltage sensors
(No. 33612 and 33613) connected to the model from
up to two batteries (BAT-1 and BAT-2). They also
show the corresponding temperature: On the left side,
you can see the data of sensor 1 and on the right side,
you can see the data of sensor 2.
The right half of the display shows graphically and
numerically the current cell voltages of the (max.) 7
cell battery pack connected to balancer connection 1
(L) and possibly 2 (H).
It has the following meaning:
Value Explanation
QUA Signal quality expressed as percentage
m/s m/s - Climb/Sink
m/3s m/3s Climb/Sink
A Actual current
V Actual voltage
mAh Battery capacity in mAh
ALT Current altitude
1-BAT-2 BATT 1 and BATT 2
1-TEMP-2 Temperature of sensors 1 and 2
BAT-1/ Cell voltage of cells 1... max. 14
BAT-2
L = Balance port 1
H = Balance port 2
228 Telemetry data display
VARIO
BACK NEXT QUA 100
270.0 270.0 270.0
m/s m/3s m/10s
-270.0 -270.0 -270.0
+000.1 000.0
-000.5
This display visualizes the data of a Vario module con-
nected to the receiver (No. 33601).
It has the following meaning:
Value Explanation
QUA Transmitter signal quality received by
the receiver expressed as percentage,
see page 101.
MAX Maximum level in meters relative to
the starting location
MIN Maximum altitude below the starting
location in meters
m/s m/s - Climb/Sink
m/3s m/3s Climb/Sink
m/10s m/10s Climb/Sink
GPS
BACK NEXT QUA 100 DIST
000
N 000°00 0000 O 000°00 0000
m/s m/3s
200
100 300
SPEED
000km/h
000.0 000
0 400
This display shows the data of a GPS module with
an integrated Vario module connected to the receiver
(No. 33600).
In addition to the current position data and model
speed in the center of the display, the current height
is displayed in relation to the starting location along
0000m
MAX
with the ascent and descent of the module in m/ s and
m/3 s; the current reception as well as the distance
from the starting location are also shown.
-0001m
It has the following meaning:
Value
MIN -0002m
QUA
DIST.
N / W
m/s
m/3s
kmh
ALT
Notice
If the telemetry connection is interrupted, for any
possible reason, for longer than three seconds
and if the transmitter is not switched off, the last
correctly transmitted GPS coordinates are saved in the
flash memory of the transmitter. Those data can be read
00000m
on the GPS display if necessary using the control but-
tons of the transmitter accordingly to go back to the
main menu or to recall the GPS display.
0000m
ALT
Explanation
Transmitter signal quality received by
the receiver expressed as percentage,
see page 101.
Distance
North/west
m/s - Climb/Sink
m/3s Climb/Sink
Speed above ground calculated by the
GPS system
Current altitude relative to the starting
location