GRAUPNER mz-24 Pro Programming Manual page 201

BACK LANDING Airbrake
ACT ON CTL SW 6
AILE1 AILE2
RATE 000% 000%
Touch
The color of the value fi eld switches from black to
blue:
BACK LANDING Brake
ACT EIN CTL SW 6
AILE1 AILE2
000%
RATE 000%
In the active (blue) value fi eld, press
the current value within a range of ±150% and
reduce it, for example:
BACK
LANDING Airbrake
ACT ON CTL SW 6
AILE1 AILE2
RATE +023% 000%
Use the same procedure for the value of the aileron
on the opposite side as well as any inboard ailerons.
RES
Touch the button to reset a changed value in the
blue (and hence active) fi eld to the default value.
After completing the settings for the ailerons, you
SERVO
can switch to the page for setting the fl aps by touch-
NEXT
ing at the right edge of the display to set the
NEXT
fl aps and enter the desired settings using the proce-
INC
dure described above, for example:
RES
DEC BACK
ACT
RATE
SERVO
NEXT
To prevent the sudden defl ection of (brake) fl aps ad-
INC
justed in this manner when activating the selected
RES
control, touch the
DEC
display to go to the last display of this option. Incor-
porate a delay for the defl ection of the fl aps as de-
scribed above, for example:
+ to increase
– to
BACK
AIRBRAKE DELAY
SERVO
NEXT
INC
RES
DEC
Tip
Smoothly retract the fl aps by setting up a "LAND-
ING" phase in addition to the "NORMAL" phase in the
"PHASE" sub-menu, and incorporate a switching de-
lay. For the switch, use the same control that (is to be)
used to trigger the braking function.
LANDING Airbrake SERVO
INH CTL ON
NEXT
INC
FLAP1 FLAP3 FLAP4 FLAP2
–035% –045% –045% –034% RES
DEC
NEXT button at the right of the
PHASE 1 AIRBRAKE SERVO
1.2s NEXT
INC
RES
DEC
After you have fi nished making your settings, touch
BACK
the button at the top left of the display to return
to the menu selection:
BACK BASE FUNCTION
Phase D/R,EXPO THR.CRV Idle LOW
Snap roll Aile diff Wing MIX Flap MIX
Airbrake TTrainer Logical sw Sequence
Function menu | Airplane models - brakes
SYSTEM
Prog.MIX
Flap set
V-Tail
201