GRAUPNER mz-24 Pro Programming Manual page 130

The sequence in which the up to 5 points between
the end points "L" and "H" are generated does not
matter since the support points are automatically
renumbered sequentially from left to right after one
support point is set or deleted, for example:
BACK PHASE 1 THR.CRV
CURVE OFF
IN –050%
–050%
OUT
POINT 1 –025%
ST ON X-axis Y-axis
Deleting a support point
In order to delete the set support points 1 to 5,
move the vertical green line with the control stick
next to the relevant support point. Once the sup-
port point number appears along with the associ-
ated value in the line "POINT" and the point is red
(see the screen-shot below), you can delete it by
touching the ENT button, for example:
BACK PHASE 1 THR.CRV
CURVE OFF
IN 000%
OUT 000%
POINT 2 +050%
ST ON X-axis Y-axis
BACK PHASE 1 THR.CRV
OFF
CURVE
IN 000%
OUT 000%
POINT ?
000%
ST ON X-axis Y-axis
130 Function menu | general - Curve CH 1
Changing the support point value
• X-axis button
Activate this function by touching the button at the
bottom edge of the display.
You can then move an active (red) point to the right
+
with the
SERVO
ton, for example:
INC
DEC
ENT
Touch the
function.
Notices
• If you move the red point horizontally away
from the current control position, the point
becomes green after a short while, and a
SERVO
"?" appears in the Point line. This question
mark does not relate to the point which
has been moved but rather indicates that
INC
another point can be set at the current
Touch
control position.
DEC
• Remember that the percentages in the
ENT
"IN"(put) and "OUT"(put) line always refer
SERVO to the momentary position of the control
stick and not to the position of the point.
• Y-axis button
INC
Activate this function by touching the button at the
bottom edge of the display.
DEC
ENT
(X-axis)
–
button, and to the left with the
BACK SERVO
PHASE 1 THR.CRV
CURVE OFF
IN 000% INC
OUT +018%
DEC
POINT ? 000%
ST ON X-axis Y-axis ENT
X-axis
button again to deactivate the
(Y-axis)
You can then move an active (red) point to the top
+
with the button, and to the bottom with the
button, for example:
BACK PHASE 1
but-
CURVE
IN
OUT
POINT
ST ON
Touch the Y-axis button again to deactivate the
function.
Notice
Remember that the percentages in the "IN-
"(put) and "OUT"(put) line always refer to the
momentary position of the control stick and
not to the position of the point.
Rounding off the throttle curve
• ON/OFF button in the "Curve" line
The default angled curve profile can be automati-
cally rounded off by turning on the rounding func-
tion by pressing this button, for example:
BACK PHASE 1
CURVE
IN
OUT
POINT
ST ON
–
THR.CRV SERVO
OFF
INC
–030%
+035%
DEC
2 +067%
Y-axis
X-axis ENT
THR.CRV SERVO
OFF
–030% INC
Touch
+035%
2 +067% DEC
X-axis Y-axis ENT