Changing The Support Point Value; X-Axis; Y-Axis - GRAUPNER mz-24 Pro Programming Manual

Between the two endpoints "L" and "H", up to
5 additional support points can be set, and the
distance between neighboring support points
may not be less than approximately 25%.
Move the control stick. As long as a ? is next to
the "POINT", you can set the next support point
by touching the ENT button. At the same time,
the "?" is replaced with a number:
WIZ. NORMAL PIT.CRV
Pitch min. FORWARD TRIM
Curve OFF
INC
ON +050%
OUT +050%
POINT 1 +050% DEC
ST ON

X-axis

Y-axis

ENT
The sequence in which the up to 5 points be-
tween the end points "L" and "H" are generat-
ed does not matter since the support points are
automatically renumbered sequentially from left
to right after one support point is set or delet-
ed, for example:
PIT.CRV
WIZ. NORMAL
Pitch min. FORWARD TRIM
Curve OFF
INC
IN –050%
OUT –050%
DEC
POINT 1 –050%
ST ON X-axis Y-axis ENT
Deleting a support point
In order to delete the set support points 1 to 5,
move the vertical line with the control stick next
to the relevant support point.
Once the support point number appears along
with the associated value in the line "POINT"
and the point is red (see the screen-shot be-
low), you can delete it by touching the
button, for example:
WIZ. NORMAL PIT.CRV
Pitch min. FORWARD TRIM
Curve OFF
INC
IN 000%
000%
OUT
Touch
POINT 2 000% DEC
ST ON X-axis Y-axis ENT
WIZ. PIT.CRV
NORMAL
Pitch min. FORWARD TRIM
Curve OFF
IN 000% INC
OUT 000%
POINT DEC
? 000%
ST ON X-axis Y-axis ENT

Changing the support point value

• X-axis button
Activate this function by touching the button
at the bottom edge of the display.
You can then move an active (red) point to
the right with the + button, and to the left
with the – button, for example:
WIZ. NORMAL PIT.CRV
Pitch min. FORWARD TRIM
Curve OFF
IN 000% INC
OUT 000%
POINT 2 000% DEC
ST ON X-axis Y-axis ENT
X-axis
Touch the
vate the function.
Tips
ENT
• If you move the red point horizontally away
from the current control position, the point
becomes green after a short while, and a
"?" appears in the Point line. This question
mark does not relate to the point which
has been moved but rather indicates that
another point can be set at the current
control position.
• Remember that the percentages in the
"IN"(put) and "OUT"(put) line always refer
to the momentary position of the control
stick and not to the position of the point.
• Y-axis button
Activate this function by touching the button
at the bottom edge of the display.
You can then move an active (red) point to
the top with the
with the – button, for example:
(X-axis)
WIZ. NORMAL
Pitch min. FORWARD
ST ON
Y-axis
Touch the
the function.
Base menu - Model selection
button again to deacti-
(Y-axis)
+ button, and to the bottom
PIT.CRV
TRIM
Curve OFF
IN –044% INC
OUT +027%
POINT 2 +044% DEC
X-axis Y-axis ENT
button again to deactivate
49