Throttle Cut - GRAUPNER mz-24 Pro Programming Manual

Throttle Cut

Switchable throttle cut or motor limiter
This sub-menu is not shown in model type "glider with-
out motor".
In the basic transmitter display, use your fi nger or the
provided stylus to touch the gear icon labeled "B":
000%
000:00.0
000 000
mz
0:01:23 000:00.0
Touch
M - 1
000 000
PHASE 1
MODELLNAME 1
BATT TIME 00: 01: 23
000
The display switches to the "green" base menu.
Touch the menu item
"THR.CUT".
BACK BASE FUNCTION
Model Sel Model Type E.P.A REV/SIB
TX ctl Timer Fail Safe Trim Step
CTL Set Out.Swap Telemetry Announce
Throttle Cut
In this "Throttle Cut" option, you can turn off a speed
controller with a switch, or move a servo for the throt-
tle control in the pre-defi ned motor OFF position (or
to idle position).
This option can also be used as an emergency OFF
function as well. The motor OFF position, or also an
idle position, is designated in the value fi eld of the
66 Base menu - Motor stop
"SET" line and needs to be determined through ex-
perimentation.
The speed controller or the throttle servo only as-
sumes the set position if a freely selectable switch has
been activated ...
• By moving the selected switch to the ON posi-
tion the speed controller or the governor will be
reduced to the value which has been input in the
000%
"SET" line, independently from the actual position
4.2V of the throttle/brake or throttle/pitch control stick.
... and in models with ICE engine also this passage
must be performed:
000
• If the set percentage in the "SET" line is less than
the current servo position, that is, the current servo
position represented by the green arrow to the left
of the bar graphic is above the switching threshold
represented by the red arrow in the bar graphic,
SYSTEM
the speed controller reduces the motor speed, or
the throttle servo closes the carburetor as speci-
fi ed in the "SET" line once the servo position falls
Motor
below the switching threshold of -66% when the
Touch
switch is in the ON position.
Servo
• If the control stick position, represented by the
green arrow on the left of the bar graphic, is actu-
ally under the red arrow on the right of the graph-
ic, the speed controller or governor increases the
motor speed or the throttle servo opens the car-
buretor as specifi ed in the "SET" line, after moving
the switch to the ON position as soon as the con-
trol stick moves over +66% or under -66% of the
switch threshold if the motor OFF position is set in
the plus side.
• In this motor OFF position, the speed controller or
the governor are disabled until the selected switch
is not moved again.
The preset value of the fi eld in the "SET" line of the
idle or "motor off" position is -100% of the throttle/
brake or throttle/pitch control stick travel:
BACK PHASE 1 THR.CUT
ACT INH

CTL ON
 SET –100%
Programming
To change the default for the "Motor OFF" posi-
tion, touch the value fi eld in the "SET" line:
BACK PHASE 1 THR.CUT
ACT INH

Touch
CTL ON
 SET –100%
The color of the fi eld switches from black to blue:
BACK THR.CUT
PHASE 1
ACT INH

CTL ON
 SET –100%
SERVO
INC
RES
DEC
SERVO
INC
RES
DEC
SERVO
INC
RES
DEC