Helicopter Models - GRAUPNER mz-24 Pro Programming Manual

Helicopter models

All of the relevant menus for helicopter models are
identified in the following "Program description" sec-
tion with the symbol that characterizes this model
type...
... so that you only have to deal with these menus
when programming helicopter models.
Installation notices
Notice
The servos must be connected to the receiver in
the indicated sequence. Outputs that are not re-
quired are simply not assigned.
Follow the instructions on the subsequent pages.
Tip
In order to take advantage of the comfort and safety fea-
tures of the "Thr.Limit", a governor should be connected
to receiver output "6" instead of receiver output "8" in
the adjacent receiver configuration. More information on
this subject can be found on page 161.
Receiver assignment for helicopter models ...
... with 1 to 3 swashplate servos
free or special function
free or special function
free or governor or special function
free or special function
receiver power supply
gyro suppression
throttle servo or motor controller
free or special function
tail servo (gyro-system)
Nick-1-servo
Roll-1-servo
Pitch- or Roll-2 or Nick-2-servo
receiver power supply
free or special function
... with 4 swashplate servos
free or special function
free or special function
free or governor or special function
free or special function
receiver power supply
gyro suppression
throttle servo or motor controller
Nick-2-servo
Tail-servo (gyro-system)
Nick-1-servo
Roll-1-servo
Roll-2-servo
receiver power supply
free or special function
Notice
In comparison to the receiver configuration of
some older Graupner/JR transmitters, servo
connection 1 (pitch servo) and servo connection
6 (throttle servo) have been switched. The servos must
be connected to the receiver outputs as depicted on the
right. Outputs that are not required are simply not as-
signed.
More details on the swashplate type can be found in
the menu "Model selection".
Receiver assignation 31